How to Use Golf Rangefinder Monocular

My first experience with a golf rangefinder monocular wasn’t pleasing. I had no choice but to resort to seeking help from friends who know. Of course, that will be a whole lot of distractions, and if you were the one, you’d not enjoy it. But what happened next was what led me to be an expert. To get your golf rangefinder check it at wildewoodwoodcreek.com

Well, before I could master it, I read lots of books. These books, I thought, would give me the insight that I needed, and I was glad it did. After taking my time to research the subject thoroughly, I was happy that I got the basics. After that, I built on what I’ve read and sharpened my skills, and eventually, I became an expert who is now going to teach you how to get this right. 

But remember that your situation isn’t the first, nor will it be the last. The guide below is a step by step approach. Therefore, at the end you would have obtained the fundamental concept. So what I demand from you now is to be calm and read in this comprehensive guide. Let’s kick start! 

How to Use Golf Rangefinder Monocular

Concisely, a monocular is referred to as a binocular that’s cut right into 2 pieces. The specially marked lines of the lens are capable of helping a golfer determine the hole from the ball. And with the right gauging of the distance, a golfer can select the most fitting and appropriate club to be used. 

When using RM (Rangefinder monocular), you should take cognizance of the views. There are two views. These are unobstructed and obstructed views. 

In dealing with any of these views, you would need to adopt lots of techniques. For instance, by the name, unobstructed views, this is a situation whereby nothing is standing in between the golf ball and the target. 

On the flip side, an obstructed view indicates a situation where several things stand in between the target and the player. But here’s a question:  How can a person go about these different views? Let’s further break it down for simplicity. Let’s begin with an unobstructed view

Unobstructed View

Unobstructed views offer a straightforward procedure. Take, for example, the initial process is to stand behind the golf ball. Then, by utilizing rangefinder scope, you can then locate what’s regarded as the flag post that’s using the “Green line” you will find on the scope. 

The moment you can figure that out, that is finding the flap stick by utilizing the Green line. You will then need to tilt the scope so you can align the green line to the bottom of the flag. This process demands complete precision and care. 

When you are tilting the scope, be sure to align the scope in a manner that the green line would adopt a perpendicular position. This is the only way to obtain accurate results. 

By adopting the scale, take note of the number you have in your scope that relates to the peak of the flag post. The related number stands for the distance, which can also be called the yardage from the ball down to the target. Isn’t that easy? Of course, it is! 

Let’s quickly analyze the steps for this type of view:

  • Stand very close to the ball and maintain a clear view of your hole, which is your target. 
  • To one eye, the rangefinder monocular should be held 
  • Then, match that line on the viewfinder that’s been marked green to the base of the flag post. 
  • Take(note) the numbers lined alongside the flag post tip
  • Then, select the relevant golf club in line with the distance that has been specified. 

Now, to obstructed view

Obstructed View

Obstructed Views have some difficulties for users who use them. If the bottom of the flag post isn’t showing, then you’d need to adopt a different process for verifying the distance. In a situation like this, it would be nice to assume that you are utilizing a stripped flag post. Then what can you do? 

The first step you will have to take is to stand at the back of the golf ball. After that, you can then use the green line to find out the flag post. Then, you will now match the same green line to the least visible strip of the flap stick. For you to successfully match the lowest strip to the green line, you must title the scope gently and calmly. 

Next, you should hold the scope in an angle allowing the green line to be perpendicular right to the flag post. If you wouldn’t be able to accomplish that, you will have inaccurate measurements. 

Then, notice the grid number that corresponds to the peak of the flag post. Also, note the one that surfaces on the scale of the viewfinder.

When you are done identifying the grid number, then multiply it by the number of identifiable strips you find on the flag post. Finally, divide the answer you got by 8. 

What you get after dividing by 8 is the number of yardage from the ball down to the target. 

Let’s take an example:

Let’s say, the peak of the flag on the viewfinder scale is equivalent to 500. Then on the flagstick, let’s say we have 5.

The distance will be (5×500)/8 = 312.5 yards. 

Let’s quickly analyze the steps for this type of view:

  • Start by lining up the last strip of the flag post that has the lowest line in the scope of the viewfinder. 
  • Locate the number that’s corresponding with the peak of the flag post
  • What’s next is to do the counting of the number of strips to the peak of the flag post. 
  • Multiply both the number of strips and the number that lines up together with the one on the peak of the flag’s post. 
  • Divide results 
  • The result for the step by step is the distance.

Only with these two steps will you know how to utilize the gold rangefinder. Sadly, there are many who aren’t on the know. 

Tips

When utilizing a rangefinder scope right on an unobstructed view, you will figure out that these steps are simple and easy. Notwithstanding, with the obstructed view, the flag can be stripped.

But what will a person do when his flag post is lacking an obstructed view? Well, this is a cunning situation. More so, it’s not possible to arrive at an accurate result in an obstructed view. 

One of the best practices in golf is for a golfer to keep its scope clean. Always clean it with a soaked clean cloth after each use. And you will need to blow off dust away from the lenses and scope

Conclusion 

You will have to learn this regularly; it’s not as simple as a brisk walk. The entire process broken down in this guide helps you perform better when you combine it with little practice.